Test Result Evaluation
WARNING: This page is about a different variant/trim than selected.
Evaluating the Battery Test Results for the Warranty and Service Tests
| Battery Test Result | Measure |
|---|---|
| Battery -A- good | No measure on the Battery -A-. |
| Battery -A- good - recharge | -- Charge the Battery -A- (Refer to BATTERY, CHARGING ) and determine why the battery is discharging. |
| Perform a current draw test | -- Perform a current draw test. Refer to CURRENT DRAW TEST . -- Charge the Battery -A- and perform the test again. Refer to BATTERY, CHARGING . |
| Battery -A-, replacing | -- Disconnect The Battery -A- And Perform The Test Again. The Result "Replace The Battery" Can Occur Due To A Weak Cable Contact. |
| Battery cell faulty - replace | -- Replace the Battery -A-. Refer to BATTERY, REMOVING AND INSTALLING . |
| Check the connection | -- Attach The Test Terminals Directly To The Battery -A- And Not To The Battery Jump Start Terminal. |
Evaluating The Battery Test Results For The Maintenance Test
| Battery Test Result | Measure |
|---|---|
| Battery -A- good | No measure |
| Battery -A-, charge immediately | -- Charge the Battery -A-. Refer to BATTERY, CHARGING . |
| Mark as defective | -- Mark the Battery -A- as "defective". |
| Check the tester connection | -- Disconnect The Battery -A- And Perform The Test Again. The Result "Check The Tester Connection" Can Occur Because The Cable Contact From The Test Terminals Is Weak. |
| Check the connection | -- Attach The Test Terminals Directly To The Battery -A- And Not To The Battery Jump Start Terminal. |
| Noises | Wait Until The Measured Value Appears In The Display. |