Battery, Charging With Battery Charger :Vas5906: Procedure

WARNING: This page is about a different variant/trim than selected.

-- Place The :VAS5906 In The Engine Compartment Or Under The Vehicle.

-- Connect The :VAS5906 To The Power Supply.

The :VAS5906 Is In Idle, The Display Comes On When It Is "Ready To Be Used".

WARNING:

Risk Of Injury. Follow All Warning Messages And Safety Precautions. Refer To WARNINGS AND SAFETY PRECAUTIONS .

CAUTION:

Turn Off The Ignition And All Electrical Equipment.
Remove The Key.

-- Connect The Red Charge Terminal (+) To The Positive Terminal Of The Battery -A-.

NOTE:

On Vehicles With A Start/Stop Function And An Installed Battery Monitoring Control Module -J367-, The Black Charge Terminal (-) Must Be Connected To The Body Ground. The Start/Stop System Will Malfunction When It Is Connected To The Battery -A- Negative Terminal.

-- Connect The Black Charge Terminal (-) To The Negative Terminal Of The Battery -A- /Negative Connector.

The Charging Process Starts After Approximately Two Seconds.

Leds Show The Battery -A- Charge Level. When All The Lamps Are On, The Battery -A- Is Charged.

When The Battery -A- Is Completely Charged, The :VAS5906 Automatically Switches To Maintenance Charging.

CAUTION:

Sparks Can Result If The Charging Terminals Are Removed Too Early. End The Charging Process By Pressing The START/STOP Button.

Battery -A- Charging, Ending

-- Press The START/STOP -Button.

-- Remove The Charging Clamps From The Battery Terminals.

-- Disconnect The :VAS5906 From The Power.