Severely Discharged Battery, Charging With Battery Charger :Vas5900: Procedure
-- Turn Off The Ignition And All Electrical Consumers And Remove The Ignition Key.
-- Connect The :VAS5900 To The Power Supply. The Last Selected Mode Is Shown On The Display. Refer To BATTERY CHARGER .
-- Set The Battery Type With The INFO Button.
The Symbol -1- For "Service Charge Of Wet Batteries" Or The Symbol -2- For "service Charge Of Gel/Absorbent Glass Mat (AGM) Batteries" Is Indicated In The Display.
-- Set The Battery Capacity (Ah) On The Battery -A- To Be Charged With The Corresponding ↑ button or ↓ button.
-- Connect the red charge terminal (+) to the positive terminal of the Battery -A-.
On vehicles with a Start/Stop function and an installed Battery Monitoring Control Module -J367-, the black charge terminal (-) must be connected to the body ground. The Start/Stop system will malfunction when it is connected to the Battery -A- negative terminal.
-- Connect the black charge terminal (-) to the negative terminal of the Battery -A- /negative connector.
-- Press the START/STOP button for about 5 seconds. The menu selection "Charging severely discharged batteries/Support mode" is activated.
-- Press the corresponding ↑ -button or ↓ button to adjust the battery voltage(6 V/12 V/24 V).
If No Button Is Touched Within Five Seconds, The :VAS5900 Will Return To The Main Menu (Operating Mode Selection).
-- Select The Battery Voltage By Pressing The START/STOP button.
Then The Inquiry About The Correct Polarity Of The Charging Clamps Is Made.
-- Check Correct Polarity Connection Of Charger Clamps.
-- Confirm charging clamps are connected to correct poles via START/STOP Button.
The :VAS5900 Starts To Charge The Severely Discharged Battery -A-.
Battery -A- Charging, Ending
-- Press The START/STOP -Button.
-- Remove The Charging Clamps From The Battery Terminals.
-- Disconnect The :Vas5900 From The Power.