Flange And Driveshaft Seals, Rear Final Drive Removed: Notes
WARNING: This page is about a different variant/trim than selected.
- It is necessary to install the old flange/driveshaft.
- If the flange/driveshaft is also being removed. Refer to FLANGE/DRIVESHAFT AND SEAL WITH REAR FINAL DRIVE REMOVED .
Special tools and workshop equipment required
- Puller VW 391
- Slide Hammer - Complete Set VW 771
- Pulling hook VW 771/37
- Thrust Piece T40112
- Retainer 3028
- Seal Driver-Frt Wheel Bearing 3143
- Adapter T10235
- Friction Meter VAS 6222
- Inductive Heat Unit VAS 6414
- Sealing grease G 052 128 A1
- Locking fluid AMV 185 101 A1
- Three M8 x 25 bolts
- 2 bolts M10 x 40