Driveshaft Bolted On Transmission Side: Installing

WARNING: This page is about a different variant/trim than selected.

Installation is in reverse order of removal. Observe the following when doing so:

Remove any old or dried-up high temperature grease from the CV joints and the driveshaft flanges. Fill with the exact same amount of high temperature grease G 000 633.
Clean any locking fluid still inside the threaded holes in the flange shafts for the transmission driveshaft and rear final drive. Use a thread cutter to clean the holes. Otherwise the bolts could break off when being installed.
After disconnecting driveshaft from rear final drive, an additional balance washer (thick washer) that may be located between shim and a bolt may not be reinstalled.
Always replace (self-locking) securing bolts for driveshaft.
Note installation position of driveshaft: Center CV joint is located behind intermediate bearing in direction facing the rear final drive.
Check the driveshaft seal on the rear final drive for damage (bent or the rubber has started to peel) Replace a damaged gasket.

-- Install the driveshaft. Pay attention to the installed position on the rear final drive:

Fig 1: Identifying Mark Position Of Driveshaft Flange To Rear Final Drive

GWWA39-10085

Courtesy of AUDI OF AMERICA, LLC

Die markings on the driveshaft -arrow A- and on the rear final drive -arrow B- must line up.
Maximum difference between the markings: 30°.

-- Install the bolts all he way in by hand but to do not tighten them.

-- Install the bolts -arrows- just far enough so that the intermediate bearing can still be moved.

Fig 2: Removing/Installing Securing Bolts For Center Bearing

GWWA39-0345

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the rear bolts -1- on the driveshaft. Follow the tightening sequence DRIVESHAFT BOLTED ON TRANSMISSION-SIDE ASSEMBLY OVERVIEW

Fig 3: Counterhold Using T10172 And T10172/5

GWWA39-10243

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the front bolts on the driveshaft. Tightening specification -5- DRIVESHAFT BOLTED ON TRANSMISSION-SIDE ASSEMBLY OVERVIEW .

Fig 4: Using T10172 To Hold Driveshaft

GWWA39-10185

Courtesy of AUDI OF AMERICA, LLC

-- Remove 3139.

-- Tighten bolts of intermediate bearing for driveshaft onto body tightening specification -8- DRIVESHAFT BOLTED ON TRANSMISSION-SIDE ASSEMBLY OVERVIEW .

-- Attach the heat shield -A- (if equipped) to the transmission -arrows-. Tightening specification DRIVESHAFT BOLTED ON TRANSMISSION-SIDE ASSEMBLY OVERVIEW

Fig 5: Transmission Heat Shield

GWWA39-10244

Courtesy of AUDI OF AMERICA, LLC

-- Install the heat shield -1-.

Fig 6: Identifying Crossmember

GWWA66-10497

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front -2- and rear -3- crossmembers, if equipped. Refer to OVERVIEW - UNDERBODY PANELS .

-- Install and adjust exhaust system free of stress. Refer to the appropriate service information .