Starter, Removing And Installing, Vehicles With 1.8L And 2.0L TFSI Engine: Removing

Fig 1: Identifying Nut And Ground Wire On Engine Mount Bracket

Courtesy of AUDI OF AMERICA, LLC

-- With The Ignition Switched Off, Disconnect The Battery Ground Cable. Refer To BATTERY, DISCONNECTING AND CONNECTING .

-- Remove The Right Engine Mount. Refer To RIGHT ENGINE MOUNT, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA] .

-- Remove The Nut -1- And Free Up The Ground Wire On The Right Engine Support.

-- Remove The Bolts -Arrows- And The Right Engine Support.

-- Remove The Bolt -1- For The Cable Holder -2-.

Fig 2: Identifying Bolt On Wiring Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect The Connector -3- By Sliding The Retainer Back And Pressing The Release Down.

Fig 3: Disconnecting Starter Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect The Wire -2- From The Starter.

-- Remove The Bolts -1- And -4- And Remove The Starter.