LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Charging System (Battery, Starter, Generator) & Cruise Control (Start/Stop System) (Coupe)) >> 27 Battery, Starter, Generator, Cruise Control >> Battery >> Battery, Removing And Installing >> Removing

Battery, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Turn Off The Ignition And Remove The Key.

CAUTION:

TDI (SCR) Vehicles 

  • After the ignition is switched off, the reducing agent goes from the metering line to the Reducing Agent Injector -N474- and back into the reducing agent active chamber.
  • Wait until all the reducing agent has been returned before working in this area. This could take up to 10 minutes after switching off the ignition.
  • Only after this is complete can the battery be disconnected. Again, this could take up to 10 minutes after switching off the ignition.

COUPE: 

Fig 1: Battery Fluid Level
GWWA27-10139Courtesy of AUDI OF AMERICA, LLC

-- Lift the luggage compartment floor and engage it on the body.

-- Remove the nut -1- and remove the cover -2- for the vehicle tool kit.

Sportback:

Fig 2: Identifying Nut -1- And Tool Kit Cover -2-
GWWA27-10228Courtesy of AUDI OF AMERICA, LLC

-- Remove the luggage compartment floor panel cover.

-- Remove the nut -1- and the tool kit mount -2-.

-- If equipped, remove the subwoofer. Refer To Sound System .

NEGATIVE TERMINAL COVER - VERSION I: 

Fig 3: Identifying Battery Retainer Bracket -2-
GWWA27-10106Courtesy of AUDI OF AMERICA, LLC

-- Remove the tool kit mount -3-.

-- Remove the bolts -A arrows-.

-- Remove the retaining bracket -2- for the vehicle tool kit cover.

-- Release clips -B arrows- using a screwdriver and remove the negative terminal cover -1-.

-- Connect The Battery Charger For Battery Support Mode. Refer To SUBWOOFER -R211-, REMOVING AND INSTALLING .

NEGATIVE TERMINAL COVER - VERSION II: 

Fig 4: Identifying Tool Kit Mount -2-, Screws -Arrows- And Bracket -1-
GWWA27-10196Courtesy of AUDI OF AMERICA, LLC

-- Remove the vehicle tools mount -2-.

-- Remove the bolts -arrows- and remove the bracket -1-.

-- Connect The Battery Charger For Battery Support Mode. Refer To BATTERY, CHARGING WITH BATTERY CHARGER :VAS5900 .

Continuation For All Vehicles: 

Fig 5: Check Battery For Secure Fit
GWWA27-10140Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nut -4- several turns and remove the battery ground cable terminal clamp from the battery terminal.

-- Remove the cover -3- over the positive terminal.

-- Loosen the nut -2- several turns and remove the battery positive cable terminal with the Fuse Panel A -SA- from the battery terminal.

-- Disconnect the hose -5- for the central venting system.

-- Remove the bolt -6- from the battery bracket -7-.

-- Remove the battery -1- from the battery mount.

-- Remove battery from luggage compartment.

WARNING:

Pollution Risk.