Battery, Removing And Installing: Installing: Procedure

WARNING: This page is about a different variant/trim than selected.

The Vehicle Diagnostic Tester Is Connected.

-- Select the Diagnostic mode and start the diagnosis.

-- Select the Test plan tab.

-- Press the Select individual tests button and select the following one after the other:

The Vehicle Diagnostic Tester continues from here onward.

When the battery is reconnected, the following steps must be performed:

Activate the one-touch up/one-touch down power window regulators. Refer To the Owner's Manual.
Check DTC memories of all control modules and erase "Undervoltage" DTC if necessary. Refer To Vehicle Diagnostic Tester.

NOTE:

After reconnecting the power supply, the ESP warning lamp can only go out after the vehicle has been driven a few meters.