Passenger Occupant Detection System Deactivation After A Collision, Market-Specific

WARNING: This page is about a different variant/trim than selected.

Each Time An Airbag Or Passenger Belt Tensioner Deploys, A Basic Setting Must Be Performed On The Passenger Occupant Detection System Control Module. Refer To Vehicle Diagnostic Tester.
If The Seat Rails And/Or Seat Pan Is Replaced After An Accident Due To Deformations Resulting From A Crash, The Passive Occupant Detection System Must Be Replaced Using The "Passive Occupant Detection System Service Kit". It Is Then Necessary To Perform A Basic Setting To The Passenger Occupant Detection System Control Module Vehicle Diagnostic Tester.