Front Three-Point Seat Belt, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install in reverse order of removal. Note the following:

-- If parts of the seat belt system are removed due to an accident, replace the belt system mounting bolts.

NOTE:

Make sure the connectors are installed correctly and are secure.

-- Insert the belt tensioner with the anti-twist mechanism -1- in the mount -2- in direction of -arrow- and tighten the bolt.

Fig 1: Identifying Anti-Twist Mechanism And Mount

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY .

-- After installing the three-point seat belt on the front passenger side, check the child seat anchorage function of the belt. Refer to SEAT BELT FOR CHILD SEAT, CHECKING CHILD SEAT RESTRAINT FUNCTION, MARKET-SPECIFIC .