Passenger Occupant Detection System, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Follow all safety precautions when working with pyrotechnic components (refer to SAFETY PRECAUTIONS ) and on the passenger occupant detection system (refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC ).
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
WARNING:
The replacement part (service kit) for the passenger occupant detection system is already precalibrated and must not be separated under any circumstances. The service kit consists of:
- Passenger Occupant Detection System Control Module -J706-
- Passenger Occupant Detection System Pressure Sensor -G452-
- Passive Occupant Detection System Mat
- Seat cushion
- Wiring harness between the Passenger Occupant Detection System Control Module -J706- and Passenger Occupant Detection System Pressure Sensor -G452-.