Component Location Overview - Passenger Occupant Detection System
WARNING: This page is about a different variant/trim than selected.
WARNING:
The replacement part (service kit) for the passenger occupant detection system is already precalibrated and must not be separated under any circumstances. The service kit consists of:
- Passive Occupant Detection System Control Module -J706
- Passive Occupant Detection System Pressure Sensor -G452
- Passive Occupant Detection System Mat
- Seat cushion
- Wiring harness between the passenger occupant detection system control module -J706 and passenger occupant detection system pressure sensor -G452.
WARNING:
Follow all safety precautions when working on the passenger occupant detection system. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .
NOTE:
The passenger occupant detection system is only installed in the front passenger seat.
- Passenger Occupant Detection System Pressure Sensor -G452-
- Is a component of the passenger occupant detection system mat
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Do not disconnect the electrical connector
- Seat Pan
- Retaining Clip
- Cushion
- For the lower seat frame
- Do not separate from the passenger occupant detection system mat -6-
- Retaining Clip
- Do not release.
- Mat
- For the passenger occupant detection system
- Is a component of the Passenger Occupant Detection System Pressure Sensor -G452-
- Do not separate from the lower seat frame cushion -4-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Mount
- For the Passenger Occupant Detection System Control Module -J706-
- Expanding Pin
- For securing the mount to the lower seat frame
- Wiring Harness
- Do not separate from the Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
- Front Passenger Seat Position Sensor -G554-
- Is a component of the wiring harness -9-
- Removing and installing. Refer to SEAT POSITION SENSOR WITH PASSENGER OCCUPANT DETECTION SYSTEM FOR PASSENGER AIRBAG DEACTIVATION, REMOVING AND INSTALLING .
- Passenger Occupant Detection System Control Module -J706-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Do not disconnect the electrical connector