LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Passenger Protection, Airbags, Seat Belts (Coupe)) >> 69 Passenger Protection, Airbags, Seat Belts >> Knee Airbags >> Knee Airbag With Igniter, Removing And Installing >> Knee Airbag With Igniter, Removing And Installing, Front Passenger Side >> Installing

Knee Airbag With Igniter, Removing And Installing, Front Passenger Side: Installing

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

Install in reverse order of removal and note the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.

Make sure the wires do not get caught.

-- Replace the airbag securing components after airbag deployment.

WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals