Driver Side Knee Airbag With Igniter, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING .

-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY .

-- Remove the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING, VEHICLE WITH KNEE AIRBAGS .

Fig 1: Disengaging Driver Side Knee Airbag From Hook -2- & Tab -7- & Remove It Downward

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Disconnect the connector -3-.

-- Pull the retainer -2- in the direction of the -arrow- and disconnect the connectors -1 and 3-.

Fig 2: Pulling Locking Mechanism And Disconnecting Electrical Harness Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1, 4, 5 and 8-.

Fig 3: Disengaging Driver Side Knee Airbag From Hook -2- & Tab -7- & Remove It Downward

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the driver side knee airbag from the hook -2- and the tab -7- and remove it downward.

-- Lay the driver knee airbag so the padding faces up.