Overview - Driver Side Airbag, Attached Airbag Version
WARNING: This page is about a different variant/trim than selected.
- Locking Bracket
- Use a T25 TORX screwdriver, approximately 100 mm long
- Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138- and Steering Angle Sensor -G85-
- Overview. Refer to SENSORS
- 4-Spoke Steering Wheel
- Equipment levels
- Overview. Refer to OVERVIEW - STEERING WHEEL .
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all pyrotechnic components safety precautions. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .
- 3-Spoke-Steering Wheel
- Equipment levels
- Overview. Refer to OVERVIEW - STEERING WHEEL .
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all pyrotechnic components safety precautions. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .