Airbag Connector, Replacing, Bolted Airbag Version: Installing
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
Install in reverse order of removal. Note the following:
NOTE:
Make sure the connectors are installed correctly and are secure.
WARNING:
- Follow all pyrotechnic components safety precautions. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Connect the connector -1- to the airbag igniter in direction of -arrow A-.
-- Install the connector locking mechanism -2- in direction of -arrow B-. While doing this, the connector is pushed into the airbag igniter and locks into place.
Installation is performed in reverse order of removal, while noting the following:
NOTE:
Make sure the connectors are installed correctly and are secure.