LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Passenger Protection, Airbags, Seat Belts (Coupe)) >> 69 Passenger Protection, Airbags, Seat Belts >> Battery Interrupt Igniter >> Battery Interrupt Igniter, Removing And Installing >> Installing

Battery Interrupt Igniter, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install in reverse order of removal. Note the following:

NOTE:

Make sure the connectors are installed correctly and are secure.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY .

-- Check the DTC memory for the Airbag Control Module -J234- and correct any error if necessary using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals