LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Hydraulic Components - Brake System (Coupe)) >> 47 Hydraulic Components >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different variant/trim than selected.
Component Fastener Size Nm
Brake booster to mounting bracket bolt - 25
Brake fluid reservoir cover bolt - 5
Brake hose to rear brake caliper - 12
Brake line to brake hose bracket - 12
Brake line to brake master cylinder - 16
Brake line to front brake hose - 17
Brake line to hydraulic unit
-- 5 mm diameter M10 brake line - 12
-- 5 mm dimater M12 brake line - 12
-- 8 mm diameter M12 brake line - 16
Brake line to intermediate piece - 12
Brake master cylinder to brake booster nut - 49
Pedal support bolt - 20
Vacuum hose to vacuum pump bolt (with 2.0L and 3.2L engines) - 5
Vacuum pump bolt (with 2.0L and 3.2L engines) - 9
Vacuum pump bracket nut (with 3.0L and 4.2L engines) - 200
Front Brake Caliper, 1LT
Bleeder screw to brake caliper housing (2) - 10
Brake caliper to brake carrier guide pin - 30
Front Brake Caliper, 1LA/1LJ
Bleeder screw to brake caliper housing (2) - 15
Brake caliper to brake carrier bolt - 30
Brake carrier to wheel bearing housing bolt - 196
Front Brake Caliper, 1LW
Brake carrier to wheel bearing housing bolt - 196
Brake line to brake caliper connection - 14
Brake line to brake line connection - 14
Rear Brake Caliper
Bleeder screw to brake caliper housing (2) - 10
Brake caliper housing to brake carrier bolt (1) - 35
(1) Always replace
(2) Apply a thin coat of assembly paste G 052 150 A2 to the threads before installing