Vacuum Pump, FSI V6,: Installing

WARNING: This page is about a different variant/trim than selected.

NOTE:

Replace the seal.

Make sure the seal is correctly installed.

-- Position the vacuum pump tappet so it engages in the groove on the camshaft when vacuum pump is installed.

-- Insert the vacuum pump.

-- Make sure the seal is seated correctly.

-- Install and tighten all the screws on the vacuum pump sealing flange, refer to -Item 1- 1.

-- Push the new hose clamps over the vacuum hose.

-- Push the vacuum hose over the connection to the vacuum pump.

-- Compress the hose clamp on the vacuum pump connections with pliers.

-- Carefully install the engine covers into the retaining bolts one after the other.