Master Brake Cylinder: Installing

Install in reverse order of removal.

-- Replace sealing ring between brake master cylinder and brake booster.

-- When replacing brake master cylinder, ensure pressure rod in brake booster is seated correctly.

-- Press brake pedal down slightly. This makes it easier to guide the push rod into the brake master cylinder.

-- Install new nuts -3- and tighten. Note torque.

-- Install brake lines -2- on brake master cylinder. Note torque.

-- Install the brake fluid reservoir, refer to BRAKE FLUID RESERVOIR .

-- With manual transmissions, insert the clutch hydraulic line -5- into the brake fluid reservoir.

-- Fill the brake fluid up to the marking.

-- Bleed the brake system, refer to BRAKE SYSTEM, BLEEDING .

-- With manual transmissions, bleed the clutch, refer to General Information (0B2) or to [For engine(s) CAUA] General Information (0B4) .

-- Install the plenum chamber bulkhead, refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Install the tower brace, refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Install the engine cover.

-- Install plenum chamber cover, refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Perform ESP driving and system test.