Protective Cap And Guide Pin, 1LA/1LJ: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!

-- Press the retaining spring -7- in the center.

Fig 1: Brake Caliper Exploded View

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The spring is tensioned, keep hands protected.

When removing the spring, make sure it does not scratch the brake caliper or damage the paint.

-- Remove the retaining spring carefully.

-- Remove the bolts -1- on the brake caliper.

-- Remove the brake caliper.

NOTE:

Do not let the brake caliper hang from the brake hose. Secure it to the body with suitable cable ties or wire. Do not support the weight with the brake hose.

-- Remove the protective cap -2- on the outside from the groove on the guide pin.

Fig 2: Brake Caliper Exploded View

Courtesy of AUDI OF AMERICA, LLC

-- Pull the guide pin -3- outward out of the protective cap.

-- Remove the protective cap from the brake caliper.