Brake Fluid Reservoir: Installing
Remove the protective cap on the new brake fluid reservoir just before filling it.
-- Coat the plugs on the brake fluid reservoir with brake fluid.
-- Insert the brake fluid reservoir in the sealing plugs in the brake master cylinder.
-- Push the lower locking pin through the brake fluid reservoir.
-- Connect the electrical connector from the brake fluid level warning switch -F34-.
-- With manual transmission, connect the clutch hydraulic line -5- to the brake fluid reservoir.
-- Fill the brake fluid up to the marking.
-- Bleed the brake system, refer to BRAKE SYSTEM, BLEEDING .
-- With manual transmissions, bleed the clutch, refer to Description and Operation (0B2) or to [For engine(s) CAUA] Description and Operation (0B4) .
-- Install the brake fluid reservoir cover over the brake fluid reservoir.
The brake fluid reservoir cover is not installed on all vehicle models.
-- Install plenum chamber cover, refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .