Brake Lamp Sensor: Removing
-- Remove the driver side storage compartment -1 to 3-.
-- Disconnect the connector -C- for the footwell vent.
-- Remove the footwell vents -A-B-.
-- Disconnect the electrical connector to the brake light sensor.
The stop -17- on the brake pedal is an assembly aid during production and does not need to be installed again.
-- Press the brake light sensor plunger -10- all the way in using a finger.
-- With the plunger pressed in, rotate the colored piece on the brake light sensor left as far as the stop to release the switch.
The plunger must remained pressed in when releasing the brake light sensor.
-- Let go of the brake light sensor plunger after releasing.
-- Insert a T40168 between the brake light sensor plunger and the brake pedal.
The cone on the tool must face in the direction of the driver seat. The opening on the tool must align with the bulge on the brake light sensor.
-- Press the T40168 against the brake lamp sensor. This releases the three retaining tabs on the brake lamp sensor.
-- Remove the brake lamp sensor from the mount.