Abs Hydraulic Unit -N55- With Abs Control Module -J104- Overview
WARNING: This page is about a different variant/trim than selected.
- ABS Hydraulic Unit -- with ABS Control Module --
- Component location: in the left of the engine compartment.
- Removing and Installing, refer to ABS HYDRAULIC UNIT -N55- WITH ABS CONTROL MODULE -J104- .
- The hydraulic control unit is comprised of the ABS hydraulic unit N55 with integrated brake pressure sensor G201 and the ABS control module J104.
- The components must not be separated from each other.
- Do not disconnect the connector before successfully completing OBD.
- Switch the ignition off before disconnecting the connector.
- The brake pressure sensor G201 is integrated into the ABS hydraulic unit N55 and cannot be replaced.CAUTION:
The ABS hydraulic unit N55 and ABS control module J104 must not be separated from each other.
- ESP Bracket
- The bracket cannot be removed.
- ABS Control Module -- Electrical Connector
- Brake Line
- To the brake master cylinder.
- 14 Nm
- Brake Line
- To the brake master cylinder.
- 14 Nm
- Brake Lines
- Hydraulic unit to right front brake caliper.
- 14 Nm
- Hydraulic unit to front left brake caliper.
- 14 Nm
- Hydraulic control unit to rear left brake caliper.
- 14 Nm
- Hydraulic control unit to rear right brake caliper.
- 14 Nm