LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Mechanical Components - Brake System (Coupe)) >> 46 Mechanical Components >> Removal And Installation >> Rear Brakes >> Rear Brake Shield >> Installing

Rear Brake Shield: Installing

WARNING: This page is about a different variant/trim than selected.

-- Position the brake shield.

-- Install the bolts on the brake shield and tighten them.

-- Install the rear brake rotor, refer to REAR BRAKE ROTOR .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure the brake hose is correctly installed and secured inside the bracket on the stub axle carrier. So that the brake hose does not come out of the bracket on its own.

-- Mount the wheels.

Wheel bolt tightening specification, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower the vehicle.

scientia non olet · About LEMON Manuals