Rear Brake Pads: Installing
Clean brake caliper with mineral spirits exclusively.
-- Insert the brake pad retaining springs.
-- Remove any protective film from the brake pad backing plate.
-- Install the brake pads.
-- Make sure that the brake pads are seated correctly in the retaining plates -arrows-.
The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake rotor and brake pad.
-- Position the brake caliper.
The repair kit includes new self-locking hex that must be installed in all cases.
-- Secure brake caliper using new self-locking bolts.
To tighten the bolts use V.A.G 1331 with V.A.G 1331/3.
-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.
Make sure the brake hose is correctly installed and secured inside the bracket on the stub axle carrier. So that the brake hose does not come out of the bracket on its own.
-- Turn on the ignition.
Displayed on the vehicle diagnostic tester display.
- The request to enter a display group number appears in display field -1-.
- An entry keypad is shown in display field -2-.
-- Using the entry keypad, enter in display field -2- the "006" for the display group number and confirm by pressing the "Q button". (guide pistons together).
-- To exit the entry template, press the green arrow button at the lower left.
DTC memory interrogated, errors shown corrected and DTC memory erased.
-- Disconnect the vehicle diagnostic tester from the 16-pin diagnostic connector in the vehicle with the ignition switched off.
-- Mount the wheels, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Check the brake fluid level and fill if necessary.