Rear Brake Caliper With Brake Carrier: Installing
Use new bolts.
-- Carefully press the brake caliper with the brake carrier and the brake pads installed over the brake rotor.
-- Tighten the brake carrier with new bolts -16 and 17-.
Use an extension to tighten the lower screw -16-. An extension is not needed to tight the upper screw -17-. Slightly move the wheel housing liner away.
-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.
Make sure the brake hose is correctly installed and secured inside the bracket on the stub axle carrier. So that the brake hose does not come out of the bracket on its own.
-- Mount the wheels.
-- Lower the vehicle.
Wheel bolt tightening specification, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Turn on the ignition.
Displayed on the vehicle diagnostic tester display.
- The request to enter a display group number appears in display field -1-.
- An entry keypad is shown in display field -2-.
-- Using the entry keypad, enter in display field -2- the "006" for the display group number and confirm by pressing the "Q button". (guide pistons together).
-- To exit the entry template, press the green arrow button at the lower left.
DTC memory interrogated, errors shown corrected and DTC memory erased.
-- Disconnect the vehicle diagnostic tester from the 16-pin diagnostic connector in the vehicle with the ignition switched off.