Brake Pads: Removing

WARNING: This page is about a different variant/trim than selected.

-- Raise the vehicle.

-- Remove the wheels.

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!

-- Remove the caps -13-.

Fig 1: Identifying Brake Caliper Components

Courtesy of AUDI OF AMERICA, LLC

-- For vehicles with the brake wear pad indicator, disconnect the left front connector -4-.

-- Lift securing strap slightly at bottom of connector and then rotate 90°.

-- Remove the lower part of the brake pad wear indicator connector from the bracket.

-- Using screwdriver, pry off brake pad retaining spring from brake caliper housing and remove.

Fig 2: Identifying Brake Pad Retaining Spring From Brake Caliper Housing

Courtesy of AUDI OF AMERICA, LLC

-- Loosen and remove both guide pins -12- from the brake caliper.

Fig 3: Identifying Caliper Guide Pins, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Secure the brake caliper to the vehicle with a suitable wire. Do not support the weight with the brake hose.

-- Remove brake pads from brake caliper housing or from brake carrier.