Brake Pads: Removing
The brake caliper must not be removed to remove the brake pads.
When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!
-- Raise the vehicle.
-- Remove the wheels.
-- Disconnect the brake pad wear indicator on the left brake caliper.
-- Remove the wear indicator wire from the left bracket.
-- Slide the upper and lower guide pins -10- out of the brake caliper while holding the retaining spring in place.
Spring is tensioned and can cause injury when guide pins are removed.
-- Remove the upper and lower springs -12-.
-- Press the brake pistons back with the T10145.
The brake pistons with the old pads still installed can pressed back to allow all brake pistons in the brake caliper to be pressed back evenly.
Before removing old brake pads, press brake piston into cylinder using resetting tool.
Be careful not to damage the coating on the brake caliper.
Before pushing back the piston, siphon some of the brake fluid out of the brake fluid reservoir. Otherwise, especially if reservoir has been topped off, fluid will overflow and cause damage.
Brake fluid is poisonous. NEVER siphon brake fluid with your mouth!
-- Remove the upper and lower brake pads from the caliper.
-- Clean the brake caliper housing.
Clean brake caliper with mineral spirits exclusively.