Front Brake Caliper With Brake Carrier: Installing

WARNING: This page is about a different variant/trim than selected.

NOTE:

Use new bolts.

-- Carefully press the brake caliper with the brake carrier and the brake pads installed over the brake rotor.

-- Tighten the brake carrier with new bolts -1-.

Fig 1: Freeing Up Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Insert the brake hose in the bracket -4-.

-- Insert the electrical wire in the bracket -2- and engage it to the right -B-.

-- Mount the wheels.

Wheel bolt tightening specification, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower the vehicle.