Electromechanical Parking Brake Control Module -J540-: Installing

WARNING: This page is about a different variant/trim than selected.

-- Connect the electrical connector -2- on the control module.

Fig 1: Connecting Electrical Connectors On Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Slide the retainer on the connector back and lock it.

-- Insert the control module.

-- Install the nuts and tighten to 9 Nm.

Install the trailer mode control module and bracket, if applicable. Bracket, 3 Nm.

-- If the electronic parking brake control module is replaced, select the "Replace" function for the respective control module in "Guided Fault Finding".

NOTE:

Use the vehicle diagnostic tester.