Brake Pedal, Manual Transmission: Install

WARNING: This page is about a different variant/trim than selected.

NOTE:

Install the brake pedal on the removed mounting bracket.

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

Fig 1: Identifying Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

Be careful not to damage the stop -17- on the brake pedal. The brake lamp sensor mount -10- could break when the brake pedal is unlocked.

-- Slide the right retainer onto the pins.

-- Slide the pins from right to left through the axle in the brake pedal.

-- Secure the pins with the left retainer -1-.

Fig 2: Identifying Brake Pedal, Removal And Installation Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The pins must be secured with the retainers on both sides.

Fig 3: Identifying Brake Pedal, Removal And Installation Overview

Courtesy of AUDI OF AMERICA, LLC

-- Install and tighten the bolt -3-.

-- Install the mounting bracket, refer to MOUNTING BRACKET, MANUAL TRANSMISSION .