Brake Pedal, Automatic Transmission: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

Be careful not to damage the stop -17- on the brake pedal. The brake lamp sensor mount -10- could break when the brake pedal is unlocked.

-- Slide the left retainer -12- onto the pins.

-- Slide the pins from left to right through the axle in the brake pedal.

-- Secure the pins with the right retainer -5-.

Fig 2: Identifying Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The pins must be secured with the securing clips -5 and 12- on both sides.

-- Install and tighten the bolt -11-.

NOTE:

Clip the brake pedal to the brake booster.

-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.

-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .

-- Install the footwell vents -A-B-.

Fig 3: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -C- on the footwell vent.

-- Install the driver side instrument panel cover -1 to 3-.

Fig 4: Identifying Driver Side Storage Compartment

Courtesy of AUDI OF AMERICA, LLC