Brake Booster Plunger Mount: Removing

WARNING: This page is about a different variant/trim than selected.

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

-- Remove the driver side instrument panel cover -1 to 3-.

Fig 1: Identifying Driver Side Storage Compartment

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -C- on the footwell vent.

Fig 2: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Remove the footwell vents -A-B-.

-- Remove the brake lamp sensor -10-, refer to BRAKE LAMP SENSOR .

Fig 3: Identifying Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

-- Separate the brake pedal from brake booster, refer to BRAKE PEDAL AND BRAKE BOOSTER, DISCONNECTING AND CONNECTING .

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

-- Pry the brake booster plunger mount -15- out of the brake pedal using a suitable tool.

Fig 4: Identifying Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.