Brake Booster Plunger Mount: Installing

WARNING: This page is about a different variant/trim than selected.

-- Insert the brake booster mount and ball socket in the brake pedal.

The mount must engage audibly.

NOTE:

Clip the brake pedal to the brake booster.

-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster until the ball head engages audibly.

-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .

-- Install the footwell vents -A-B-.

Fig 1: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -C- on the footwell vent.

-- Install the driver side instrument panel cover -1 to 3-.

Fig 2: Identifying Driver Side Storage Compartment

Courtesy of AUDI OF AMERICA, LLC