Rear Brakes With Electronic Parking Brake Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
Only install complete repair kit.
Rear wheel brake with automatic adjustment.
- Self-Locking Bolt
- 12 Nm
- Electromechanical Parking Brake Actuator
- Electromechanical parking brake control module, removing and installing, refer to Electromechanical Parking Brake Control Module -J540- .
- Actuator, removing and installing, refer to ELECTROMECHANICAL PARKING BRAKE ACTUATOR .
- Seal
- Always replace.
- Self-Locking Bolt
- 35 Nm
- Always replace.
- When loosening and tightening, counter-hold at guide pin.
- Spacer
- Brake Hose
- To the brake caliper, 20 Nm.
- Do not disconnect brake line when changing brake pads.
- Make sure that retaining tabs are seated correctly in bracket.
- Install hose without twisting.
- Brake Caliper Housing
- Do not remove the brake hose when changing the brake pads.
- Brake caliper, servicing.
- It is possible to install brake carrier with brake caliper.
- Removing and Installing, refer to REAR BRAKE CALIPER WITH BRAKE CARRIER .
- Replacing, refer to REAR BRAKE CALIPER, REPLACING .
- Brake Carrier with Guide Pins and Cap
- Supplied as an assembled replacement part with sufficient grease on guide pins.
- If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins.
- It is possible to install brake carrier with brake caliper.
- Removing and Installing, refer to REAR BRAKE CALIPER WITH BRAKE CARRIER .
- Brake Pads
- Wear limit, refer to BRAKES PR CODES .
- Must always be replaced together on both sides of axle.
- Removing and Installing, refer to REAR BRAKE PADS .
- Checking brake pad thickness
- It is possible to install brake carrier with brake caliper.NOTE:
The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake rotor and brake pad.
- Brake Pad Retaining Plate
- Always replace when pads are replaced.NOTE:
The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake rotor and brake pad.
- Always replace when pads are replaced.
- Wheel Bolts
- Wheels, Mounting, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
- Bolt
- 5 Nm
- Brake Rotor
- Wear limit, refer to BRAKES PR CODES .
- Removing and Installing, refer to REAR BRAKE ROTOR .
- Must always be replaced together on both sides of axle.
- Brake rotor allocation, refer to BRAKES PR CODES .
- Hex Head Bolts
- 10 Nm
- Brake Shield
- Removing and Installing, refer to REAR BRAKE SHIELD .
- Bolt
- 100 Nm + 90° turn
- Replace
- Bolts
- 100 Nm + 90° turn
- Replace