LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Gears, Shafts - Manual Transmission Internal Components 0B2 AWD (Coupe)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Output Shaft >> Removing The Roller Bearing From The Output Shaft

Removing The Roller Bearing From The Output Shaft

WARNING: This page is about a different variant/trim than selected.
Fig 1: Removing Roller Bearing From Output Shaft
GWWA35-10133Courtesy of AUDI OF AMERICA, LLC

A - Separating device 22 to 115 mm, for example Kukko 17/2

NOTE:

The roller bearing will get damaged when it is being removed, therefore always replace it.

The roller bearing cage can also get damaged when removing using a screwdriver. Then mount the separating tool on the inner race.

Install the 3rd and 4th gear wheels and the roller bearings on the output shaft.

scientia non olet · About LEMON Manuals