Output Shaft: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Thrust Plate VW 401
- Thrust Plate VW 402
- Punch VW 407
- Thrust Disc VW 412
- Tube 60 mm Dia. VW 415 A
- Sleeve VW 519
- Slide Hammer-Complete Set VW 771
- Driving Sleeve 32 - 109
- Sleeve 40 - 21
- Seal Driver 3013
- Tube 3296
- -1- Internal Puller Kukko 21/1
- -3- Separating Tool Kukko 17/2
- Inductive Heater VAS 6414
NOTE:
Removing and installing 1st, 2nd and reverse gears. Refer to SHIFT FORK GROUP, INPUT SHAFT, 1ST, 2ND AND REVERSE GEAR OUTPUT SHAFTS .
Remove the 3rd and 4th gear wheels and the roller bearings from the output shaft.
-- Remove the 4th gear wheel locking ring.