Fastener Tightening Specifications: Notes
WARNING: This page is about a different variant/trim than selected.
| Component | Fastener Size | Nm |
|---|---|---|
| All Wheel Drive Clutch Valve to Hydraulic Control Unit Housing Bolt | - | 2.5 |
| All Wheel Drive Pump to Hydraulic Control Unit Housing Bolt | - | 5 |
| Automatic Transmission Fluid Drain Plug to Final Drive Housing | - | 15 |
| Automatic Transmission Fluid Inspection Plug to Left Chamber | - | 15 |
| Bracket for the Wiring Harness | 9 | |
| Center Bearing | - | 20 |
| Drive Axle Heat Shield to Rear Final Drive Bolt | - | 20 |
| Driveshaft Center Bearing to Body Bolt | - | 20 |
| Driveshaft to Rear Final Drive Flange Bolt 1 | - | 30 + 90° |
| Driveshaft to Transmission Flange Bolt 1 | - | 30 + 90° |
| Flange Shaft to Rear Final Drive Bolt 1 | - | 50 + 180° |
| Gear Oil Inspection Plug to Final Drive Housing | - | 15 |
| Hydraulic Control Module to Final Drive Housing Bolt | ||
| M8 2 | 20 | |
| M8 3 | 20 | |
| M8 4 | 30 | |
| Left Pipe Installed between the Hydraulic Control Unit and the Left Chamber, Nuts | - | 30 |
| Left/Right Chamber to Final Drive Housing Bolt | - | 24 |
| Oil Pressure/Temperature Sensor to Hydraulic Control Unit Housing | - | 10 |
| Right Pipe Installed Between the Hydraulic Control Unit and the Right Chamber, Nuts | - | 30 |
| Shuttle Valve to Hydraulic Control Unit Housing | - | 8 |
| Subframe to Rear Final Drive | ||
| - Lower Bolt | - | 55 |
| - Rear Bolt | - | 95 |
| Wiring Harness Bracket to Right Chamber Bolt | - | 5 |
| Wiring harness bracket to the rear final drive | - | 9 |
|
||