Flange/Driveshaft Seal, Rear Final Drive 0BF: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools and workshop equipment required
- Puller VW 391
- Puller T10055
- Adapter T10055/2
- Two M8 x 30 bolts
- Thrust Piece T10380
- Assembly Tool T40222
- Guide sleeve T40222/1
- Sealing grease G 052 128 A1
- Inductive heat unit VAS 6414
- or
- Hotplate
- and
- Digital thermometer VAS 6519