Flange/Driveshaft Ring

Special Tools and workshop equipment required 

• Needle Bearing Drift VW 295 A
• Thrust Plate VW 402
• Punch VW 408 A
• Support Channels VW 457
• Separating Device 22 to 75 mm, for example Kukko 17/1

Fig 1: Identifying Ring -A- From Flange/Driveshaft, Removal

Courtesy of AUDI OF AMERICA, LLC

B - Separating Tool 12 to 75 mm, for example Kukko 17/1

Fig 2: Identifying Ring -A- Must Be Installed With Elevation -Arrow 1- Into Chamfer -Arrow 2- On Flange -B-. Smaller Outer Circumference Face Flange -Arrow 3-

Courtesy of AUDI OF AMERICA, LLC

• The ring -A- must be installed with the elevation -arrow 1- into the chamfer -arrow 2- on the flange -B-. The smaller outer circumference face the flange -arrow 3-.

Fig 3: Identifying Ring -A- Onto Flange/Driveshaft, Installation

Courtesy of AUDI OF AMERICA, LLC

• The ring -A- must clip into the chamfer in the flange Fig 2.