All Wheel Drive (AWD): Pump: Removing

WARNING: This page is about a different variant/trim than selected.

-- Place the vehicle on a hoist.

-- Place the drip tray under the rear final drive.

-- Disconnect the connector -1- from the All Wheel Drive (AWD) pump -V415- -2-.

Fig 1: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the 4 AWD pump bolts on the hydraulic control unit using the T10058.

-- Carefully remove the AWD pump -2- while paying attention to the adapter, refer to item 4 in the hydraulic pump.

NOTE:

The adapter could fall out when removing the AWD pump.
Insert the adapter into the recesses in the hydraulic pump before installing the AWD pump.