Vacuum Pump, Removing And Installing, 4.0L TFSI Engine: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the cylinder bank 2 catalytic converter (left). Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .
-- Remove the nut -3-.
-- Remove bracket -5- from bolt -4- and push slightly aside.
-- Remove the bolt -4- and the banjo bolt -2-.
-- Remove oil line -1-.
CAUTION:
There is a Risk of damaging the vacuum hoses.
- Carefully remove the vacuum hoses. A damaged vacuum hose must be replaced.
-- Loosen the hose clamp -1- and remove the vacuum hose.
-- Remove the bolts -arrows-, pull the vacuum pump from the cylinder head and remove.