Vacuum Pump, Removing And Installing, 2.5L/2.8L/3.0L TFSI Engine: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
NOTE:
Replace the seal after removal.
Secure all hose connections with standard production hose clamps.
-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning -arrows-.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING - CREC .