Check Valve With Vacuum Hose In Engine Compartment, Removing And Installing, 3.0L TDI Engine: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Remove the bracket for the A/C compressor. Refer to BELT PULLEY SIDE, SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
-- Loosen the hose clamp -arrow- and remove the air duct hose.
CAUTION:
There is a Risk of damaging the vacuum hoses.
- Carefully remove the vacuum hoses. A damaged vacuum hose must be replaced.
-- Remove the vacuum hose -2-.
-- Remove the bolt -1-.
-- Disconnect the vacuum hose -3- by pressing the release buttons on both sides.
-- Remove the bolt -2- and remove the vacuum hose -1- with the check valve.