Brake Booster Pressure Sensor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the cowl panel trim. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING . .
-- Disconnect the connector from the Brake Booster Pressure Sensor -G294- -arrow-.
-- Release clips with pliers -1-.
-- Carefully pry out the Brake Booster Pressure Sensor -G294- -2-.