Overview - Rear Brake Caliper
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening specification -item 6- OVERVIEW - REAR BRAKES, STEEL BRAKES .
- Brake Caliper Housing
- Bleed Screw
- Tightening specification -item 4- OVERVIEW - REAR BRAKES, STEEL BRAKES .
- Protective Dust Cap
- Seal
- Coat with a thin layer of lithium grease.
- Thrust Nut
- For actuating the parking brake
- Brake Caliper Piston
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING .
- Coat with a thin layer of lithium grease.
- Guide Pin
- Grease before pulling on the bearing bushing
- Delivered as a replacement part with sufficient grease.
- Bearing Bushing
- Pull onto the brake carrier and guide pin.
- Brake Carrier
- With guide pin and bearing bushing
- Delivered as an assembled replacement part with sufficient grease on the guide pins
- Install the repair kit if the caps or guide pins are damaged. Use the supplied grease packet to lubricate guide pins.
- Protective Cap
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING .