Hydraulic System, Bleeding With Brake Charger/Bleeding Unit: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Brake Charger/Bleeder Unit :VAS5234 with Brake Bleeder Adapter :VAS5234/1
- or
- Brake Filling and Bleeding Equipment :VAS6860 with Brake Charger/Bleeder Unit - Adapter :VAS5234/1A
- Brake Bleeding Tool Set :VAS6564
- Wrench - Brake Bleeder Set :VAS5519
- Container
Read the operation manual for :VAS5234 or :VAS6860 .
-- Fill the brake fluid reservoir with brake fluid up to the "max" mark.
-- Fill the brake fluid reservoir up to the "MAX" mark.
-- Connect the :VAS5234 or :VAS6860 to the :VAS5234/1 .
-- Adjust the correct pressure on the :VAS5234 or :VAS6860 . Refer to Owner's Manual.
-- Remove the left and right front dust caps -1-.
-- Remove the left and right rear dust caps -1-.
NOTE:
Use a suitable bleeder hose. It must be seated tightly on the bleed screw so that no air can enter the brake system.
-- Attach the bleed hose from the reservoir to the bleed screw.