Bearing Bushing And Guide Pin, Replacing, Steel Brakes 1LF/1LL: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, STEEL BRAKES, 1LF/1LL .
-- Pull the guide pin -1- outward from the bearing bushing.
-- Pull the bearing bushing -2- out of the brake caliper.
-- Insert the bearing bushing into the brake caliper.
- The bearing bushing must be seated in the center of the brake caliper.
-- Thinly coat the guide pin with grease from the repair kit.
-- Push the guide pin into the bearing bushing.
-- Check the movement of both guide pins.
- Both guide pins must be able to slide.
-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, STEEL BRAKES, 1LF/1LL .