Brake Fluid Reservoir, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Coat the plugs on the brake fluid reservoir with brake fluid.
-- Insert the brake fluid reservoir -3- into the plugs in the brake master cylinder.
-- Slide the locking pin -1- through the brake fluid reservoir and the master brake cylinder until it engages in the retaining tabs -2-.
-- Connect the connector to the Brake Fluid Level Warning Switch -F34-.
-- If equipped install the protective plate.
-- Fill the brake fluid to the "MIN" mark.
-- Bleed the brake system. Refer to HYDRAULIC SYSTEM, BLEEDING .
NOTE:
It must be bled on each bleeder screw. Bleed the brake caliper with two bleed screws first on the inner screw.
WARNING:
Risk of accident!
- Make sure the brakes are working correctly before driving the vehicle for the first time.